American-time Wireless Digital 2.3 Elapsed Timer with Code Blue Manuel d'utilisateur télécharger pdf (Page 9)

AppendixMaintenance

Code Blue

OperationControl StationClock/Timer

Control Station Installation Instructions

The ATSTCS Control Station can be mounted to a double gang box, 1

/2 inch deep or deeper. The Control Station can be

mounted up to 30 feet away from the Digital Clock/Timer. The recommended minimum interconnecting eld wire size is

#22.8 AWG stranded wire. Ensure that installation conforms to the National Electrical Code and local wiring codes.

CAUTION: Electric Shock Hazard! Ensure that no electrical power is present on any wire before installation.

Pull interconnecting eld wires into the double gang box.

Connect eld wiring interconnecting the ATSTCS Control Station with the Digital Clock/Timer to the appropriate wires of

the Control Station. See wiring detail below.

Mount the Control Station to the double gang box using the machine screws provided.

K2+

K2–

K1+

K1–

12VAC

UNREG

GND

PIEZO

K2+

K2–

K1+

K1–

GND

CLK

DATA

RED

BLACK

VIOLET

GREY

BROWN

BLUE

ORANGE

YELLOW

CHASSIS

NEUTRAL

120VAC

TERMINALS K2+ AND

K2– ARE USED FOR

CODE BLUE MODE

Typical wiring for the Master Digital Timer with Control Station

PIEZO

BUZZER

30 ft. maximum

#22 AWG wire

(minimum) with

1/32” insulation

(minimum)

RESET

ENTER

START/STOP

INCREMENT

CLOCK

DOWN

SET

RUN

LABEL #

H004273M

Master Clock

Terminal Block

Slave Clock

Terminal Block

nNote: Just for use if installing

master/slave clocks.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

American-time Wireless Digital 2.3 Elapsed Timer with Code Blue Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Horloge American-time Wireless Digital 2.3 Elapsed Timer with Code Blue